Oven and Stove Repair in Columbus, OH

Neighborville repairs gas and electric ovens, stoves and ranges across Columbus and the suburbs, usually the same day. In this heavily gas-heated city the call we get most is a gas oven that won’t heat while the stovetop burners still light, which points to a worn oven igniter. We also fix bake and broil elements, uneven baking, faulty burners and control boards. The $99 diagnostic is waived when you approve the repair. Call (614) 426-0274 for fast, safe oven and range service.

What Breaks Columbus Ovens and Stoves

Columbus is a gas town. With Columbia Gas of Ohio serving the city and natural gas heating the majority of Ohio homes, gas ranges and ovens are the norm across its bungalows, brick two-flats and historic districts, and that shapes the repairs we do. The single most common call is a gas oven that won’t heat: the stovetop burners light fine, but the oven stays cold because its igniter has weakened with age and can no longer open the gas safety valve. It is a defined part and a routine fix, but it is the bread-and-butter oven failure in this market in a way it never is in all-electric regions.

Electric and dual-fuel ranges add their own patterns. A bake element that shorts at the end of its life can send a voltage spike into the control board, and in older Columbus homes still running aged wiring behind the range that spike lands harder than it would on modern service. That is why we always check the board for collateral damage before ordering parts. Add the self-clean cycle, whose extreme heat is a frequent cause of blown fuses and damaged boards, and you have the short list of what actually brings Columbus ovens down. For the national troubleshooting picture, see our guide on why an oven won’t heat to the set temperature.

The Gas Oven Igniter: Columbus’s Number-One Repair

If your gas oven won’t heat but the cooktop burners light normally, the odds are heavily on the igniter, and understanding why helps explain the fix. A gas oven does not have a pilot light or a simple spark like the burners; instead it uses a glow-bar igniter that heats up and draws enough current to open the safety gas valve. As the igniter ages it still glows, but it weakens and no longer pulls the current needed to open that valve fully, so gas never reaches the burner or reaches it too slowly. The tell-tale sign is an oven that takes longer and longer to light, then eventually won’t light at all, while the stovetop is unaffected because those burners have their own separate igniters.

Because the igniter can look like it is working, glowing orange, while it has actually failed, it is one of the most misdiagnosed oven parts. A technician confirms it by measuring the current draw rather than judging by the glow, then replaces the igniter as a matched part for your range. It is a common, well-understood repair, and it is exactly the kind of fix that a proper diagnosis nails on the first visit.

Common Oven and Stove Failures We Fix in Columbus

Gas oven won’t heat, igniter

The top Columbus oven repair. The igniter glows but no longer draws enough current to open the safety valve, so the oven won’t light or reach temperature while the stovetop still works.

Electric oven no heat, bake or broil element

A visibly blistered or broken element, or one that no longer glows. Often paired with a control-board check if it shorted on the way out.

Uneven baking or won’t hold temperature

Usually a failing temperature sensor or calibration drift, so the oven runs hot or cold, or cooks unevenly front to back. We test the sensor’s resistance before replacing parts.

Surface burner problems

A gas burner that clicks but won’t light, from a clogged port or a bad igniter switch, or an electric coil or element that won’t heat, from the burner, switch or receptacle.

Control board and display

A blank display, an unresponsive touchpad, or error codes. This is the higher-cost repair, and it is common after a self-clean cycle or a surge on older wiring.

Dead after a self-clean cycle

The extreme heat of a self-clean cycle can blow the thermal fuse or fry the control board. If the oven quit right after cleaning, this is almost always the cause, and it is a frequent holiday-season call.

How We Diagnose a Columbus Oven

An oven that runs on gas and high heat deserves a careful, ordered diagnosis, and doing it in the right sequence keeps the cost down. We start by confirming whether the range is gas, electric or dual-fuel and pinning down the exact symptom: no heat, uneven heat, a dead display, or a burner fault. On a gas no-heat call we measure the igniter’s current draw before condemning it, then check the safety valve and wiring. On an electric no-heat call we test the bake and broil elements and the thermal fuse. For uneven baking we test the temperature sensor’s resistance and check calibration. Only with the real cause confirmed do we quote, in writing, and the $99 diagnostic is waived when you approve the repair, so you are never paying to guess.

Oven and Stove Repair Costs in Columbus

Typical Columbus-area ranges including parts and labor. Gas parts run slightly higher than electric. You always get a written estimate first, and the $99 diagnostic is waived when you approve the work.

Self-Clean and Oven Care in Columbus Homes

A little care prevents the most expensive oven repairs. Use the self-clean cycle sparingly and never the night before a holiday, since its extreme heat is the single most common cause of a blown thermal fuse or a damaged control board, and manual cleaning avoids the risk entirely. Keep the oven vent and the area behind the range clear so heat and any voltage spikes have somewhere to go. On gas ranges, keep the burner ports clean so the flame lights cleanly and evenly, and have any persistent gas smell checked immediately rather than living with it. And if your oven is baking unevenly, get the temperature sensor checked before you assume the whole range is failing, because a small calibration or sensor fix often restores it.

Oven and Stove Repair Across Columbus and the Suburbs

Neighborville covers oven, stove and range repair across the city and the suburbs. In town we serve German Village (43206), Short North and Victorian Village (43201), Clintonville (43214), plus Bexley, Upper Arlington and Grandview Heights. The gas-range and older-wiring patterns above are typical of this housing stock, where gas cooking is especially common.

In the suburbs we cover Franklin County (Dublin, Westerville, Hilliard, Grove City, Gahanna, Reynoldsburg, Worthington), Delaware County (Powell, Delaware) and Fairfield County (Pickerington). From a standard gas range in a Grove City kitchen to a pro-style Wolf in a Dublin build, we carry parts for the common platforms and diagnose before we quote.

Oven and Range Brands We Repair in Columbus

Oven and Stove Repair FAQ, Columbus

Other Repair Services in Columbus

Last updated: July 2026, Neighborville Appliance Repair, Call (614) 426-0274, Columbus, OH