Frigidaire Ice Maker Not Working: Checks, Fixes and Costs
Quick Answer: Frigidaire Ice Maker Not Working
A Frigidaire ice maker that has stopped is usually switched off, short of water, or full. Frigidaire’s manuals list the causes in that order, and most of them cost nothing to fix.
- Switched off: on models with a control panel, press and hold ICE MAKER for 3 seconds until the indicator light is on
- No water: the line not connected, the valve not open, a kinked supply line, or a filter not seated or clogged
- Too little water: pressure below Frigidaire’s 30 psi minimum, or a filter older than six months
- Bin full or jammed: the signal arm stops production when the bin is full; clumped ice can jam the dispenser
- New fridge: Frigidaire says the first ice can take up to 24 hours, after 2 or 3 empty cycles while air clears
Frigidaire builds ice makers into French-door, side-by-side and top-freezer refrigerators, and some French-door models carry two, one in the fresh-food door and one in the freezer. The details differ, but Frigidaire’s own troubleshooting starts in the same place on all of them: is it on, is water reaching it, and is the bin telling it to stop. This page follows that order with the figures Frigidaire publishes, then sets out what the repair costs when the checks run out.
Frigidaire still not making ice?
Tell us the model number and whether the water dispenser still runs normally, and the van comes loaded for it. The $99 diagnostic is applied to the repair when you approve it.
Frigidaire Ice Maker Troubleshooting, in Frigidaire’s Order
The troubleshooting table in Frigidaire’s French-door manual gives five causes for an ice maker that is not making any ice. Work through them in this order.
| Cause, as Frigidaire lists it | What to do | Yourself? |
|---|---|---|
| Ice maker is turned off | Press and hold the ice maker button for 3 seconds until its indicator lights | Yes |
| Not connected to the water line, or the water valve is not open | Connect the supply and open the valve fully | Yes |
| The water supply line is kinked | Straighten it, with the fridge pulled out carefully | Yes |
| The water filter is not seated properly | Remove and refit it until it locks | Yes |
| The water filter may be clogged | Replace it | Yes |
For an ice maker that makes some ice but not enough, Frigidaire’s side-by-side manual adds a useful test: check whether the water dispenser is running slower than normal. If it is, replace the filter. If it is not, the freezer may be set too warm; set it colder and allow 24 hours for the temperature to stabilize. The French-door manual adds a clogged saddle valve on the cold water pipe, very low pressure on well systems, and a reverse osmosis system in its regenerative phase, during which Frigidaire says it is normal for the pressure to fall below 20 psi.
How to Turn a Frigidaire Ice Maker On or Off
This is the cause Frigidaire lists first, and it depends on the model:
- Models with a control panel: press and hold ICE MAKER for 3 seconds. When the indicator is lit the ice maker is on; on French-door models, an Ice Maker Off indicator lights when it is off
- Older French-door models with two ice makers: the fresh-food ice maker has its own button, held for three seconds; the freezer ice maker is turned off by lifting its wire signal arm until it clicks and locks up, or by a rear On/Off switch
- Top-freezer models: the ice maker is an optional kit on most models, with its own On/Off button, and Frigidaire says it ships in the On position
Two points from the manuals are worth knowing. Turning the ice maker off only disables ice making; the dispenser still gives existing ice and water. And the signal arm is not a switch on panel models: Frigidaire says the built-in arm automatically stops production when the bin is full, and should not be used to stop the ice maker by hand.
Water Pressure, the Filter and the Supply Line
Frigidaire’s installation pages ask for a household cold water line with pressure between 30 and 100 psi, and its manuals note that excessive pressure can make the system malfunction. Low pressure shows first in the ice: Frigidaire says unusually small cubes, if they happen often, can mean low water pressure or a water filter that needs replacing.
- Filter interval: every six months, or after 120 gallons of water on the side-by-side model we checked
- Filter reset: on that model, press and hold WATER FILTER for 3 seconds to set the status back to GOOD after fitting a new one
- Water softeners: Frigidaire warns that chemicals from a malfunctioning softener can damage the ice maker
- No water connected: turn the ice maker off; Frigidaire says otherwise the fill valve can make a loud chattering noise trying to run dry
The dispenser is the quickest test of all of this. If water runs from the door dispenser at a normal rate, the supply, the pressure and the filter are fine, and the fault is closer to the ice maker. If the dispenser is slow or dry as well, the problem is upstream and the ice maker is not to blame.
New Frigidaire Not Making Ice Yet
Frigidaire’s support page for a newly installed refrigerator explains most of these calls. Air in new plumbing lines can cause 2 or 3 empty ice maker cycles before the first ice. Once the refrigerator is installed and has cooled for several hours, the ice maker can produce ice within 24 hours.
Frigidaire’s priming guidance: discard at least 1 gallon of water from the dispenser on a newly installed unit, about 8 tall glasses, and 3 to 5 glasses after a new filter. Its French-door manual describes holding a glass against the dispenser paddle for about 4 minutes to purge the air first. The top-freezer manual adds that ice made during the first 24 hours should be discarded, and that with no usage the bin takes about 1 to 2 days to fill. And because the ice maker fills the bin from the rear, Frigidaire says to dispense some ice to push it forward so the bin can fill completely.
How Much Ice Is Normal?
A common complaint is an ice maker that works but seems slow. Frigidaire publishes the output, so you can check:
| Model type | Output per 24 hours | Note |
|---|---|---|
| French door, counter depth and standard depth | 3.2 to 3.7 lbs | Bin holds about 4 lbs (counter depth) or 5 lbs (standard) |
| Top freezer with ice maker kit | 2 to 2.5 lbs | 10 cubes every 100 to 160 minutes |
| Older French door, each of two ice makers | About 2.5 lbs | Fresh-food and freezer ice makers each |
If output is well under those figures, Frigidaire’s fixes for “not enough ice” apply: check the filter and the pressure, and set the freezer colder. Frigidaire’s recommended freezer setting is 0°F, and its support page gives -6°F to 6°F as the acceptable range. A freezer above that range is a refrigeration problem, not an ice maker one, and the diagnosis is in freezer not freezing.
Ice Made but Not Dispensing
If the bin has ice but nothing comes out, the ice maker is working and the fault is in the dispenser. Frigidaire’s checks:
- Dispenser lock: on the side-by-side model, a lock-out disables dispensing; press and hold the control lock for 3 seconds
- DI SP or DISP code: Frigidaire says this means ice is jammed in the chute; remove the bin, thaw and empty it, clean and dry it, and refit it
- Cubes frozen together: remove the bin and discard the ice; Frigidaire suggests using the ice at least twice a week to keep cubes separate, and emptying the bin after a power failure of an hour or longer
Frigidaire Ice Maker Repair Cost
Ice maker work is recorded under refrigeration in our system. These are our own completed jobs, counted as jobs billed above the diagnostic fee with sales tax on it.
| Measure | Figure | Base |
|---|---|---|
| Median refrigeration repair, all makes | $375 | 247 completed refrigeration repairs |
| Middle half of refrigeration repairs | $250 to $462 | the 25th to 75th percentile |
| Frigidaire, median bill | $325 | 23 completed Frigidaire repairs, all appliance types |
| Switched off, filter, kinked line | $0 to a filter | the checks Frigidaire gives owners |
| Diagnostic visit | $99 | flat, applied to the repair on approval |
When the checks run out, the usual parts are the water inlet valve, a frozen fill tube or the ice maker assembly itself, all inside the ordinary part of the refrigeration range. Ice maker costs in more detail are in ice maker repair cost, and the make-independent chain of checks is in refrigerator ice maker not working.
What a Proper Diagnosis Checks
The ice maker’s on/off state confirmed on the panel or the arm; the freezer measured against 0°F with an instrument; the dispenser flow checked to prove the supply; the filter seated and its age noted; the supply valve, the line and any saddle valve checked; the water pressure confirmed inside Frigidaire’s 30 to 100 psi range; the fill tube inspected for ice; the inlet valve tested; the signal arm or level sensor checked; and the model number recorded so the right assembly is ordered. You get the fault named, the part named and the total before anything is ordered. Ice maker work in general is on the ice maker repair page.
Frequently Asked Questions
Why is my Frigidaire ice maker not making ice?
How do I turn on the ice maker on a Frigidaire refrigerator?
How long does a new Frigidaire take to make ice?
Why is my Frigidaire making small or not enough ice?
How often should the Frigidaire water filter be changed?
What does DI SP mean on a Frigidaire?
How much does Frigidaire ice maker repair cost?
Sources: ice maker controls, troubleshooting rows, water pressure, filter interval and reset, signal arm, priming, first-ice timing, ice output and dispenser checks are from Frigidaire refrigerator Use and Care manuals A23655704 (side by side), A23689603 (French door), A28067202 and A13110310 (top freezer) and 242288200 (French door with two ice makers), and Frigidaire owner support pages on new ice makers, priming, filter changes, the DI SP code and freezer temperature. Repair figures are Neighborville’s own completed jobs, February 2024 to September 2026, counted as jobs billed above the diagnostic fee with tax, above $108.90: 247 completed refrigeration repairs, and 23 Frigidaire repairs out of 475 with the brand logged. Neighborville is an independent repair company and is not affiliated with Frigidaire or Electrolux; brand names are used to identify the appliances we service.
Last updated: November 2026.
Check the switch and the dispenser, then call.
Whether the ice maker is on and whether the water dispenser runs normally is most of the diagnosis. Tell us both and the model number.
More on this appliance
- GE Refrigerator Ice Maker Not Working: Checks, Repair and Costs
- Ice Maker Not Making Ice – Causes, Fixes, and Costs
- Ice Maker Repair Cost
- Refrigerator Ice Maker Not Working: Work the Chain in Order
From the appliance data library
Repair costs, failure rates and lifespans, measured on our own job data.
- What 668 Real Appliance Repairs Actually Cost
- What Does Soil Mean on a Washing Machine?
- What Is an Agitator in a Washing Machine?
- What Is Perm Press on a Dryer?
- What Is the Drum of a Washing Machine?
- What to Expect From an Appliance Repair Visit
- Whirlpool Dishwasher Not Cleaning: Water, Motion, Chemistry
- Whirlpool Dishwasher Not Draining: Filter, Grinder, Pump
- Whirlpool Refrigerator Defrost Defect – Affected Models and Settlements
- Whirlpool Refrigerator Not Cooling: the Defrost Pattern
- Whirlpool Washer Not Spinning: Coupler, Actuator, Lid Lock
- Why a Washing Machine Smells, and What Actually Stops It
Need it fixed, not explained?
Booking is subject to our Terms and Conditions and Privacy Policy.